How To Take Down Roller Blinds Uk

You need a large flat surface to mark your cuts.

How to take down roller blinds uk. Open your blinds all the way and place two heavy objects at either end so that they don t retract and lie flat on your work surface. On one end will be a protruding piece of either metal or plastic which runs through the centre of the blind holding it in its place. Pull the blind cord so that the blind rolls and the fabric no longer covers the window. Head up top to the brackets and go to the side with the mechanism the bit where the chain is attached.

A large table or clean section of the floor will work just fine. Push the mechanism end of the barrel up 1 which will take the mechanism out of the bracket s lock. The tension device is the pulley system on one side of the blinds that allows you to open or close the blinds. On the other end the bracket will clamp shut around the end of the roller.

Lift the roller shade out of the bracket. Pull the roller shade off the post mounting bracket on the opposite side. This will make it easier to lift the blinds from the brackets and avoid damage. Open your roller blinds up fully until they re securely in place at the top of your window.

Locate side of the roller that has the bracket with the clamp. The barrel is connected to the mechanism which locks into the bracket. Swing open the clamp on the mounting bracket. It is best to do this as a way to protect the blind when you move it from the mounting brackets.

At the opposite end of the barrel is a pin which is sprung. Remove all obstacles and ornaments from your window sill. It s usually located on the right hand side but depending on your blinds might be on the left. These brackets hold the blind in place.

On the non pulley end there s a t or u shaped pin plug pull this out there s a small indent on the inner side to fit a screwdriver blade if more leverage is needed then push the blind down on this end from the top it will drop about 7 mm and you can now see the short pin on the end if you look through the hole where the pin plug was when lined up pull the blind towards you and hey presto it s out. Removing the blind roller blinds should have a mounting bracket on either side.