How To Take In Dress Pants Legs

How to taper pant legs.

How to take in dress pants legs. Begin ironing at the waist and slowly iron along the legs and down to the bottom of the pants. Try on the pants and pinch the excess fabric at the waist until the. How to take in pants step 1. Put your pants on and determine how much fabric you need to remove.

Remove the belt loop from the back of the pants. On your own or with the help of a friend grab the. Take pants off again and cut open the seams on the outer leg. Repeat this for the other lines.

Put on your pants inside out buttoning or zipping them fully. Turn the pants inside out and mark this distance on the inseam and side seam on both legs. Remove the bottom hem from both pant legs with a seam ripper. Use a seam ripper to pull out the thread at the areas where alterations are necessary.

As you can see there was alot. Measure the distance from the hem to the pin. This will make it easier to remove them as you sew. Tapering trousers yourself is an easy way to improve the fit of your pants and save some money in the process.

Cut out excess fabric if your feeling. Decide how much fabric to remove from the waist. After you have cut out. Mark the location of your knee on the side seam with a pin.

Take off the pants and use a seam ripper to pull out all of the. Lay the pants out flat. How to take in pant legs. Seam rip along the back of the.

Take off the pants. Taking in the waist 1. You will just need to figure where to taper the pants cut and pin the fabric and. Working from the inside of the pants insert the point of the seam ripper.