How To Use Manual Blood Pressure Device

To begin place the cuff on your bare upper arm one inch above the bend of your elbow.

How to use manual blood pressure device. Inflate the cuff by squeezing the bulb with your right hand. Rapidly squeeze the pump bulb until you no longer hear the sound of your pulse through the stethoscope. A blood pressure measurement instrument such as an aneroid or mercury column sphygmomanometer or an automated device with a manual inflate mode. Make sure the patient is relaxed by allowing 5 minutes to relax before the first reading.

How to check your blood pressure manually. When the pressure is slowly released the sound of blood. If you do not know your normal blood pressure inflate the cuff until the gauge reads between 160 to 180 mmhg. Step 2 prepare the patient.

Hold the bulb in your right hand. When you re ready to take your blood pressure sit quietly for three to five minutes beforehand. How do i do a step by step blood pressure check. Blood pressure measurement is a common diagnostic and monitoring procedure and accuracy is essential if patients are to receive the appropriate treatment and care in a timely manner.

If you have a monitor with. Once the cuff is inflated place the stethoscope with the flat side down on the inside of your elbow crease. This article part 1 in a two part series discusses principles of blood pressure monitoring and the devices used. The manual blood pressure reading is obtained with an aneroid sphygmomanometer blood pressure cuff and stethoscope.

It s difficult to use if you re hearing or visually impaired or if you re unable to perform the hand movements needed to squeeze the bulb and inflate the cuff. Stop once the gauge reads 30 to 40 mmhg above your normal blood pressure. Position your arm straight palm facing up on a level surface such as a table. This indicates that the monitor is ready.

Once obtained the nurse records it with the systolic reading this is the first sound heard over the diastolic blood pressure reading the point when the sound stops. All display symbols should appear briefly followed by a zero.